Frigidaire Washer Manuals

Most Common Frigidaire Washer Error Codes

• E10 / E11: Fill error – check that water supply valves are open, inlet hoses are not kinked, and inlet screens are clean.
• E20 / E21: Drain error – inspect the drain hose, clean the drain pump area, and remove lint, coins, or debris from the drain path.
• E23 / E24: Drain pump relay or control issue – check the drain pump and wiring. If the pump works but the code returns, the control board may need service.
• E30 / E31: Pressure sensor or water level issue – inspect the pressure hose for blockage, leaks, or loose connections.
• E41 / E42 / E43: Door lock or door switch issue – close the door firmly, clean the latch area, and inspect the door lock assembly if the washer will not start.
• E52: Motor tachometer signal error – reduce load size, restart the washer, and inspect motor wiring or speed sensor if the error repeats.
• E56: High motor current – overloaded tub, restricted basket movement, or drive motor issue may be present.
• E68: Key stuck or control panel problem – check for a stuck button, moisture near the controls, or a faulty user interface board.
• E90 / E91: Communication error – unplug the washer for several minutes and restart. If the code returns, inspect wiring between the control boards.

Front Load Frigidaire Washer Problems

• Washer will not drain: Check the drain hose height, inspect for clogs, and clean the pump filter or drain pump access area where available.
• Door will not unlock: Wait for the safety lock delay, check for standing water, then unplug the washer for several minutes before trying again.
• Water leaking from door: Clean the door gasket, remove hair, lint, and detergent residue, and inspect the door glass for trapped clothing.
• Musty odor: Leave the door open after use, wipe the rubber gasket, clean the dispenser drawer, and run a washer cleaning cycle monthly.
• Excessive vibration: Confirm shipping bolts were removed, level the washer, and avoid washing one heavy item by itself.

Top Load Frigidaire Washer Problems

• Washer not spinning: Check for an unbalanced load, lid lock issue, drain problem, drive belt wear, or motor control fault.
• Washer not agitating: Inspect the agitator, drive belt, lid switch, motor, or transmission depending on the model.
• Washer fills slowly: Clean the inlet screens, check water pressure, and make sure hot and cold supply valves are fully open.
• Clothes still wet: The washer may not have drained fully or reached full spin speed. Redistribute the load and run drain/spin again.
• Loud banging during spin: Level the washer, reduce load size, and inspect suspension components if the tub moves excessively.

Frigidaire Laundry Center Troubleshooting

• Washer section will not start: Check power, lid switch, cycle selector, and water supply. Some stacked units will pause during sensing or filling.
• Dryer section runs but washer does not: Confirm the correct cycle is selected and inspect the washer lid switch or timer circuit.
• Washer drains but does not spin: Check lid lock, belt, motor, and load balance. Avoid overloading compact laundry center tubs.
• Unit vibrates heavily: Make sure the laundry center is level, firmly supported, and not overloaded.

Maintenance Tips for Frigidaire Washers

• Use HE detergent: High-efficiency models require HE detergent. Too much soap can cause suds, odor, poor rinsing, and error codes.
• Clean the dispenser: Remove detergent and softener buildup from the drawer or dispenser cup regularly.
• Inspect hoses: Replace cracked or bulging water inlet hoses and check for leaks behind the washer.
• Keep the washer level: Adjust leveling feet to reduce vibration and prevent movement during spin cycles.
• Clean the gasket: For front load models, wipe the door boot seal after use to prevent lint, mold, and odor buildup.

Safety note: Always unplug the washer before checking hoses, cleaning filters, opening panels, or inspecting internal components. Turn off both water supply valves before removing inlet hoses. Never bypass a lid switch, door lock, thermal device, or safety sensor.